18.04.2 LTS dual boot with Win 10 Pro is causing Windows corruption












0















I'm trying to dual boot a new Dell OptiPlex 5060 Micro. I've setup it up multiple times with various configurations (typically start with Win10 install, boot, shrink partition, then install Ubuntu with defaults; did try Ubuntu install 1st, same same) but get Win10 corruption every time when using SATA III interface (I've tried Seagate 2.5” HDD 500GB, Samsung 860 EVO SSD 250GB and WD Blue SSD 1TB drive, same error with all). Once I install and use Ubuntu and switch back to Win10, Win10 will not load, either blue screens with WHEA_UNCORRECTABLE_ERROR or will not load at all (black screen, video lost and never recovers). Even if I can repair Win10, it happens again once Ubuntu is loaded. Tried just for grins Samsung 850 EVO M.2 SSD 250GB, same dual boot setup, it worked fine (always partitioning single drive, splitting drive approximately in half for each OS). So is this a software problem (I am assuming not because M.2 interface worked, and SATA III didn't), or a BIOS (UEFI) problem/error (running latest available), or hardware problem (bad). I just cannot understand why Windows Boot Manager or disk partition is getting corrupted by running Linux instance but apparently only when running drive from SATA III interface but works fine with M.2 interface.










share|improve this question

























  • It sounds as though there is some corruption occurring when running Linux. I have seen this occurring when Windows is using Intel's RST (rapid storage technology) which uses a small (16gb) SSD as a disk cache in Windows. Some Linux users have tried installing installing Linux on that small SSD which corrupts Window's "disk cache". I'm not saying this is your problem, but it may give you a direction to look that you perhaps haven't thought of.

    – TonyB
    Feb 23 at 1:10


















0















I'm trying to dual boot a new Dell OptiPlex 5060 Micro. I've setup it up multiple times with various configurations (typically start with Win10 install, boot, shrink partition, then install Ubuntu with defaults; did try Ubuntu install 1st, same same) but get Win10 corruption every time when using SATA III interface (I've tried Seagate 2.5” HDD 500GB, Samsung 860 EVO SSD 250GB and WD Blue SSD 1TB drive, same error with all). Once I install and use Ubuntu and switch back to Win10, Win10 will not load, either blue screens with WHEA_UNCORRECTABLE_ERROR or will not load at all (black screen, video lost and never recovers). Even if I can repair Win10, it happens again once Ubuntu is loaded. Tried just for grins Samsung 850 EVO M.2 SSD 250GB, same dual boot setup, it worked fine (always partitioning single drive, splitting drive approximately in half for each OS). So is this a software problem (I am assuming not because M.2 interface worked, and SATA III didn't), or a BIOS (UEFI) problem/error (running latest available), or hardware problem (bad). I just cannot understand why Windows Boot Manager or disk partition is getting corrupted by running Linux instance but apparently only when running drive from SATA III interface but works fine with M.2 interface.










share|improve this question

























  • It sounds as though there is some corruption occurring when running Linux. I have seen this occurring when Windows is using Intel's RST (rapid storage technology) which uses a small (16gb) SSD as a disk cache in Windows. Some Linux users have tried installing installing Linux on that small SSD which corrupts Window's "disk cache". I'm not saying this is your problem, but it may give you a direction to look that you perhaps haven't thought of.

    – TonyB
    Feb 23 at 1:10
















0












0








0








I'm trying to dual boot a new Dell OptiPlex 5060 Micro. I've setup it up multiple times with various configurations (typically start with Win10 install, boot, shrink partition, then install Ubuntu with defaults; did try Ubuntu install 1st, same same) but get Win10 corruption every time when using SATA III interface (I've tried Seagate 2.5” HDD 500GB, Samsung 860 EVO SSD 250GB and WD Blue SSD 1TB drive, same error with all). Once I install and use Ubuntu and switch back to Win10, Win10 will not load, either blue screens with WHEA_UNCORRECTABLE_ERROR or will not load at all (black screen, video lost and never recovers). Even if I can repair Win10, it happens again once Ubuntu is loaded. Tried just for grins Samsung 850 EVO M.2 SSD 250GB, same dual boot setup, it worked fine (always partitioning single drive, splitting drive approximately in half for each OS). So is this a software problem (I am assuming not because M.2 interface worked, and SATA III didn't), or a BIOS (UEFI) problem/error (running latest available), or hardware problem (bad). I just cannot understand why Windows Boot Manager or disk partition is getting corrupted by running Linux instance but apparently only when running drive from SATA III interface but works fine with M.2 interface.










share|improve this question
















I'm trying to dual boot a new Dell OptiPlex 5060 Micro. I've setup it up multiple times with various configurations (typically start with Win10 install, boot, shrink partition, then install Ubuntu with defaults; did try Ubuntu install 1st, same same) but get Win10 corruption every time when using SATA III interface (I've tried Seagate 2.5” HDD 500GB, Samsung 860 EVO SSD 250GB and WD Blue SSD 1TB drive, same error with all). Once I install and use Ubuntu and switch back to Win10, Win10 will not load, either blue screens with WHEA_UNCORRECTABLE_ERROR or will not load at all (black screen, video lost and never recovers). Even if I can repair Win10, it happens again once Ubuntu is loaded. Tried just for grins Samsung 850 EVO M.2 SSD 250GB, same dual boot setup, it worked fine (always partitioning single drive, splitting drive approximately in half for each OS). So is this a software problem (I am assuming not because M.2 interface worked, and SATA III didn't), or a BIOS (UEFI) problem/error (running latest available), or hardware problem (bad). I just cannot understand why Windows Boot Manager or disk partition is getting corrupted by running Linux instance but apparently only when running drive from SATA III interface but works fine with M.2 interface.







dual-boot partitioning ssd






share|improve this question















share|improve this question













share|improve this question




share|improve this question








edited Feb 23 at 7:48







masdaq

















asked Feb 22 at 22:34









masdaqmasdaq

11




11













  • It sounds as though there is some corruption occurring when running Linux. I have seen this occurring when Windows is using Intel's RST (rapid storage technology) which uses a small (16gb) SSD as a disk cache in Windows. Some Linux users have tried installing installing Linux on that small SSD which corrupts Window's "disk cache". I'm not saying this is your problem, but it may give you a direction to look that you perhaps haven't thought of.

    – TonyB
    Feb 23 at 1:10





















  • It sounds as though there is some corruption occurring when running Linux. I have seen this occurring when Windows is using Intel's RST (rapid storage technology) which uses a small (16gb) SSD as a disk cache in Windows. Some Linux users have tried installing installing Linux on that small SSD which corrupts Window's "disk cache". I'm not saying this is your problem, but it may give you a direction to look that you perhaps haven't thought of.

    – TonyB
    Feb 23 at 1:10



















It sounds as though there is some corruption occurring when running Linux. I have seen this occurring when Windows is using Intel's RST (rapid storage technology) which uses a small (16gb) SSD as a disk cache in Windows. Some Linux users have tried installing installing Linux on that small SSD which corrupts Window's "disk cache". I'm not saying this is your problem, but it may give you a direction to look that you perhaps haven't thought of.

– TonyB
Feb 23 at 1:10







It sounds as though there is some corruption occurring when running Linux. I have seen this occurring when Windows is using Intel's RST (rapid storage technology) which uses a small (16gb) SSD as a disk cache in Windows. Some Linux users have tried installing installing Linux on that small SSD which corrupts Window's "disk cache". I'm not saying this is your problem, but it may give you a direction to look that you perhaps haven't thought of.

– TonyB
Feb 23 at 1:10












1 Answer
1






active

oldest

votes


















0














I install Win10 and Ubuntu 18.04.2 in separate SSDs successfully. I make it done follow this link:Dual Boot Windows 10 and Linux Ubuntu on Separate Hard Drives



Plus:if you have RTX2080TI installed, remember, unplug the card first. After installing the newest driver 415 then plug the card.






share|improve this answer























    Your Answer








    StackExchange.ready(function() {
    var channelOptions = {
    tags: "".split(" "),
    id: "89"
    };
    initTagRenderer("".split(" "), "".split(" "), channelOptions);

    StackExchange.using("externalEditor", function() {
    // Have to fire editor after snippets, if snippets enabled
    if (StackExchange.settings.snippets.snippetsEnabled) {
    StackExchange.using("snippets", function() {
    createEditor();
    });
    }
    else {
    createEditor();
    }
    });

    function createEditor() {
    StackExchange.prepareEditor({
    heartbeatType: 'answer',
    autoActivateHeartbeat: false,
    convertImagesToLinks: true,
    noModals: true,
    showLowRepImageUploadWarning: true,
    reputationToPostImages: 10,
    bindNavPrevention: true,
    postfix: "",
    imageUploader: {
    brandingHtml: "Powered by u003ca class="icon-imgur-white" href="https://imgur.com/"u003eu003c/au003e",
    contentPolicyHtml: "User contributions licensed under u003ca href="https://creativecommons.org/licenses/by-sa/3.0/"u003ecc by-sa 3.0 with attribution requiredu003c/au003e u003ca href="https://stackoverflow.com/legal/content-policy"u003e(content policy)u003c/au003e",
    allowUrls: true
    },
    onDemand: true,
    discardSelector: ".discard-answer"
    ,immediatelyShowMarkdownHelp:true
    });


    }
    });














    draft saved

    draft discarded


















    StackExchange.ready(
    function () {
    StackExchange.openid.initPostLogin('.new-post-login', 'https%3a%2f%2faskubuntu.com%2fquestions%2f1120497%2f18-04-2-lts-dual-boot-with-win-10-pro-is-causing-windows-corruption%23new-answer', 'question_page');
    }
    );

    Post as a guest















    Required, but never shown

























    1 Answer
    1






    active

    oldest

    votes








    1 Answer
    1






    active

    oldest

    votes









    active

    oldest

    votes






    active

    oldest

    votes









    0














    I install Win10 and Ubuntu 18.04.2 in separate SSDs successfully. I make it done follow this link:Dual Boot Windows 10 and Linux Ubuntu on Separate Hard Drives



    Plus:if you have RTX2080TI installed, remember, unplug the card first. After installing the newest driver 415 then plug the card.






    share|improve this answer




























      0














      I install Win10 and Ubuntu 18.04.2 in separate SSDs successfully. I make it done follow this link:Dual Boot Windows 10 and Linux Ubuntu on Separate Hard Drives



      Plus:if you have RTX2080TI installed, remember, unplug the card first. After installing the newest driver 415 then plug the card.






      share|improve this answer


























        0












        0








        0







        I install Win10 and Ubuntu 18.04.2 in separate SSDs successfully. I make it done follow this link:Dual Boot Windows 10 and Linux Ubuntu on Separate Hard Drives



        Plus:if you have RTX2080TI installed, remember, unplug the card first. After installing the newest driver 415 then plug the card.






        share|improve this answer













        I install Win10 and Ubuntu 18.04.2 in separate SSDs successfully. I make it done follow this link:Dual Boot Windows 10 and Linux Ubuntu on Separate Hard Drives



        Plus:if you have RTX2080TI installed, remember, unplug the card first. After installing the newest driver 415 then plug the card.







        share|improve this answer












        share|improve this answer



        share|improve this answer










        answered Feb 23 at 7:55









        zpengzpeng

        1




        1






























            draft saved

            draft discarded




















































            Thanks for contributing an answer to Ask Ubuntu!


            • Please be sure to answer the question. Provide details and share your research!

            But avoid



            • Asking for help, clarification, or responding to other answers.

            • Making statements based on opinion; back them up with references or personal experience.


            To learn more, see our tips on writing great answers.




            draft saved


            draft discarded














            StackExchange.ready(
            function () {
            StackExchange.openid.initPostLogin('.new-post-login', 'https%3a%2f%2faskubuntu.com%2fquestions%2f1120497%2f18-04-2-lts-dual-boot-with-win-10-pro-is-causing-windows-corruption%23new-answer', 'question_page');
            }
            );

            Post as a guest















            Required, but never shown





















































            Required, but never shown














            Required, but never shown












            Required, but never shown







            Required, but never shown

































            Required, but never shown














            Required, but never shown












            Required, but never shown







            Required, but never shown







            Popular posts from this blog

            flock() on closed filehandle LOCK_FILE at /usr/bin/apt-mirror

            Mangá

             ⁒  ․,‪⁊‑⁙ ⁖, ⁇‒※‌, †,⁖‗‌⁝    ‾‸⁘,‖⁔⁣,⁂‾
”‑,‥–,‬ ,⁀‹⁋‴⁑ ‒ ,‴⁋”‼ ⁨,‷⁔„ ‰′,‐‚ ‥‡‎“‷⁃⁨⁅⁣,⁔
⁇‘⁔⁡⁏⁌⁡‿‶‏⁨ ⁣⁕⁖⁨⁩⁥‽⁀  ‴‬⁜‟ ⁃‣‧⁕‮ …‍⁨‴ ⁩,⁚⁖‫ ,‵ ⁀,‮⁝‣‣ ⁑  ⁂– ․, ‾‽ ‏⁁“⁗‸ ‾… ‹‡⁌⁎‸‘ ‡⁏⁌‪ ‵⁛ ‎⁨ ―⁦⁤⁄⁕