Bdtyktl

I'm working through How to Design, Build, and Test Small Liquid-Fuel Rocket Engines. The guide explains calculating a rocket nozzle throat area using Eq. (7):

$$A_t = frac{w_t}{P_t} sqrt{frac{R T_t}{gamma g_c}} $$

where $w_t$ is flow measured in lb/s, $P_t$ is pressure measured in psi, $R$ is the specific gas constant for gaseous oxygen and hydrocarbon fuel which equals 65 ft-lb/lb R(rankine), $T_t$ is temperature of the chamber measured in rankine, $gamma$ being the ratio of gas specific heats, and the gravitational constant $g_c$ measured in ft/s².

My issue is for the worked out problem on the guide, they give an example here but the answer is in in² instead of ft². I'm not sure how they got inches instead of feet because they didn't do any kind of conversion that I can tell. I tried following the units to see how they got inches but I'm not sure. Shouldn't the answer be in feet, and if not how is it inches?

$R$ and $g_c$ each have a foot component in their units; therefore the feet cancel out when $R$ is divided by $g_c$.

$P_t$ is in pounds per square inch; since you're dividing by that, it's effectively units of square inch per pound, which is where the square inches in the answer comes from.

The rest of the unit cancellation is confusing because of the use of pounds as both a unit of mass and a unit of force (weight). This thread on thespacerace.com discusses the different ways of presenting your equation; the money quote is here:

Outside the square root, my equation uses slugs for the mass flow rate, while the other equation uses pounds (i.e. weight). To convert pounds to slugs we must divide by gc outside the square root.

Inside the square root, my equation uses R' equal to 49,720 ft-lb/slug-R, while the other equation uses 1545.32 ft-lb/lb-R. To convert ft-lb/lb-R to ft-lb/slug-R we must multiple by gc inside the square root.

The combination of these two conversion factors is,

1/gc * (gc)^1/2 = 1/gc^1/2

therefore we end up with gc in the demoninator inside the square root.

That equation as you give it with the values you supply is a bad mish-mash of units. It's painful to do this in the English system, but gather your courage, we can get through it.

You must specify the flowrate in $frac{slugs}{sec}$. Yes, slugs, the real engineer's unit of mass^TM. A slug is 1 $frac {lbf - sec^2} {ft}$ and equates to ~ 32.2 lbm. So flowrate in $frac{slugs}{sec}$ has the units of $frac{lbf-sec}{ft}$.

You also must specify the pressure in $frac{lbf}{ft^2}$.

Dividing through you get outside the radical the units of $ft-sec$.

Inside the radical the gas constant is $frac{ft-lbf}{slug-R}$. The R cancels out with the temperature unit. gamma is dimensionless.

So if you substitute in $frac{lbf- sec^2}{ft}$ for the slug, you end up with $frac{ft^2}{sec^2}$ inside the radical.

Taking the square root, it's $frac{ft}{sec}$, then multiply by the $ft-sec$ outside the radical, to get $ft^2$.

Welcome to the world of Apollo and Shuttle rocket engine calculations.