Bdtyktl

I have a problem oposite to the usual one.

I have a task to hibernate my computer at 8pm
If I hibernate the computer earlier, and turn it on next morning, the task runs and hibernates the computer (what I dont wont to happen)

I HAVE NOT selectede the "Run task as soon as posible after a schedule start is missed"

Am I wrong? doesn't this means that if the task is messed, it´s not going to run ?

Alex

If you hibernate the computer before the time that the task is scheduled to start then the current clock state is saved as well (for synchronisation purposes).

Once you resume from hibernation, the OS clock is brought back into sync with the hardware clock (which now shows a time and date that is after the scheduled task). I can only think that perhaps this triggers scheduled tasks to run because the time doesn't skip straight from A to B but rather 'plays forward' the interval in-between.

I was having the similar problem. (My task was set to run at 5:30 PM and then wait for 15 minutes of inactivity before suspending.)  In my case, it would work fine so long as the computer was running at 5:30 PM every day. If it ever missed the task due to being suspended, it would run the task on resume (and yes, I had also unchecked "Run task as soon as possible after a scheduled start is missed"). It would then suspend the computer after being resumed and having 15 minutes of inactivity.

So, here's my solution:

1. Edit your task's trigger. Check "Delay task for up to:" and select "1 minute"


2. 
   

   Create a batch file named "kill.bat"

   
   
   

   
   
   @echo off
   
   timeout 10
   
   schtasks /end /tn TaskName           # (Replace TaskName with the name of your task.)
   
   

   
   
   

   You may have to tinker with the timeout number. What you're looking for is for some amount of time (in seconds) that falls between a) the time required for the OS's clock to synchronise after resume, and b) the amount of time you delayed your task to run. Setting this number can get squirrelly given that the delay time is a maximum amount and not a specific amount. Try to set this timeout as close as possible to the time needed for the OS's clock to synchronize.

   
   


3. 
   

   Create a second task – this task will run the batch file you just created upon system resume.

   
   
   

   
   
   Trigger:
   
       Begin the task: "On an event"
   
       Log: System
   
       Source: Power-Troubleshooter
   
       Event ID: 1
   
   Action:
   
       Select the batch file you created in step 2.
   
   

   
   
   

   When configured properly, this new task should run on resume and kill the original task during the 1 minute delay you added to its configuration.